Control Panel - Zanussi ZFU20223WA Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ELECTRICAL CONNECTION
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.

CONTROL PANEL

1
4
SWITCHING ON
1. Plug the appliance into electrical mains socket.
2. To turn on the appliance, touch the
temperature key until all LED indicators light up.
After approximately 3 seconds LED indicators fade
and the temperature is set to the default setting
(ECO mode). LED indicator next to ECO mode
icon illuminates.
SWITCHING OFF
1. To switch off the appliance press the
temperature key for 3 seconds.
All LED indicators turn off.
2. To disconnect the appliance from the electrical
supply, remove the mains plug from the power
socket.
TEMPERATURE REGULATION
To regulate the temperature, press the temperature
key. Every time the key is pressed, the set
temperature moves by 1 position and
corresponding LED indicator lights up. Press the
temperature key repeatedly until the required
temperature is selected. The setting will be fixed.
2
3
This appliance complies with the E.E.C.
Directives.
INSTALLATION OF THE APPLIANCE AND
DOOR REVERSAL
Please refer to separate instructions
on installation (ventilation
requirements, levelling) and door
reversal.
Temperature scale
1
Temperature key
2
ECO mode icon
3
QuickFreeze icon
4
Selection is progressive, varying from
-15°C to -24°C.
Coldest setting: -24°C.
Warmest setting: -15°C
Most suitable setting: ECO mode
(-18°C).
Choose the setting keeping in mind that the
temperature inside the appliance depends on:
room temperature
frequency of opening the door
quantity of food stored
appliance location.
SLEEP MODE OF THE DISPLAY
After 30 seconds of no interaction with the
appliance, the display goes into the sleep mode.
Only LED indicator corresponding to currently set
temperature illuminates in low light. All other LED
indicators are off. To deactivate this mode press
the temperature key.
ECO MODE
In this mode the temperature is set to -18°C.
This is the best temperature to ensure
good food preservation with minimal
energy consumption.
5

Publicité

Table des Matières
loading

Table des Matières