Operation; Control Panel; Switching Off; Temperature Regulation - Zanussi ZFT11407WA Notice D'utilisation

Operation

Control panel

1
Green Indicator Light
1
Red Indicator Light
2
Temperature Regulator
3
Switching on
Leave the appliance to stand upright for 4 hours
after installation.
Insert the plug into the wall socket.
1. The Green Indicator Light will light up and
remain lit until the appliance is switched off.
2. Leave to run for 8 hours to allow the correct
temperature to be reached before placing
food inside.
The Red Indicator Light will stay on until the
correct temperature is reached.
3. When the appliance has reached the set
temperature (the Red Indicator Light has
gone out) adjust the Temperature Regulator
according to the quantity of the stored
foods.
A few hours after starting up the
Red Indicator Light will go out to
show that the correct temperature
has been reached for the setting
chosen and will stay out to indicate
that everything is in order. It will
come on if the freezer temperature
rises unduly for instance, after
opening the freezer door or placing
food inside the cabinet, but the light
should go out again when the
temperature returns to the correct
storage level.
44
2
4
5

Switching off

1. To turn off the appliance, disconnect the
2. To disconnect the appliance from the

Temperature regulation

The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward MIN
to obtain the minimum coldness.
• turn the Temperature Regulator toward MAX
to obtain the maximum coldness.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Half Loaded position
Full Loaded position
mains plug from the wall socket.
power, disconnect the mains plug from the
wall socket.
CAUTION!
Do not place heavy nor hot objects
on top of the appliance to avoid any
damage.
A medium setting is generally the
most suitable.
3
5 4
www.zanussi.com