Alpine HALO9 iLX-F309 Guide D'installation page 9

2) After adjustment, tightly fix the display with the 4 Flush head
screws (M4×13) for up-down adjustment.
Flush head screw(M4×13)
(left and right)
3) Adjust the angle of the display.
0°
45°
20°
-20°
Refer to the illustration below to use the screw holes for angle
adjustment.
• Example:
To install the display at the angle of 20°, use the screw holes 2
and b.
0°
c
2
b
1
a
20°
2-b
4) After adjustment, secure the display with the 2 angle
adjustment screws (M4×6) (left and right) that were removed
in Step 1 on page 5.
-20°
2-c
45°
2-a
Angle adjustment screws (M4×6)
(left and right)
7
-EN