1. On/Off button
2. Operation/low battery icon
3. Camera shutter
4. Infra-red LED for nightlight
5. Microphone
6. Light sensor
7. Speaker
8. Nightlight
9. USB port
10. Operation/low battery icon
11. Connection icon
A/ TRANSMITTER
1. Battery operation
Press the cover and slide as shown. Insert three AAA
(UM-4) alkaline batteries in the compartment. Ensure
you respect the polarity. Replace the cover.
N.B.: For best operation, do not mix used and new or
alkaline and rechargeable batteries.
2. Mains operation
The transmitter can be used with mains power using
the 5V mains adaptor provided.
Connect the adaptor's outlet jack to the USB port (9)
on the transmitter, ensuring it is correctly oriented. The
battery will be shut off when the outlet jack is inserted
in the USB port (9).
B/ RECEIVER
1. Operation with rechargeable battery
The rechargeable polymer I200mAh Li battery is already
installed in the receiver. To change it, remove the belt
clip and slide off the battery cover. Disconnect the
battery connector.
2. Operation with mains adaptor
The receiver can run on mains power using the 5V mains
adaptor provided. Connect the adaptor's outlet jack
to the USB port (21) on the receiver. With the battery
installed and the receiver turned on, the Operation/low
battery icon (10) will switch from green to red, showing
that the battery is being charged.
Once the battery is charged, the Operation/low battery
icon (10) switches back to green. If the receiver is not
turned on after the 5V mains adaptor is connected to the
USB port (21), the Operation/low battery icon (10) will
remain red during charging. The battery is not damaged
if you disconnect the mains adaptor or leave it plugged
in. If you leave it plugged in, the battery's power will
not be used, and the device will run on mains power.
N.B.: Before using the receiver for the first time, charge
10
COMMANDS
12. Up key
13. Down key
14. Menu key
15. Mute key for speaker
16. Digital screen
17. Speaker
18. Microphone
19. Visual alarm
20. On/Off button
21. USB port
22. Walkie-talkie button
POWER
the Li battery for at least five hours using the mains
adaptor provided.
WARNING: TO PREVENT AN EXPLOSION, ENSURE
THAT THE BATTERY INSERTED IN THE RECEIVER IS
RECHARGEABLE BEFORE CONNECTING THE MAINS
ADAPTOR TO THE USB PORT.
YOO CARE • Instructions for use