Configuration - Niko 360-31001 Mode D'emploi

360-31001
d
4. DISMANTLING

5. CONFIGURATION

The KNX Niko dimmer switch (360-31001) provides four contacts. These are grouped into two channels (channel A and channel B) each containing two contacts (state O and state I). The contacts are referred to as AO,
®
AI, BO and BI.
Multiple radio telegrams with the state of all four contacts are transmitted whenever the energy bow is pushed together with one of the four contacts. No telegram is sent when the energy bow is released. This means that
a second push is needed to stop an action with one button dimming or one button shutter control. Use the KNX
KNX ® bus telegrams.
Up to six button combinations can be configured with the KNX
The KNX dimmer switch has two modes: normal mode (default) and configuration mode. To configure the KNX
®
1. Download the ETS files for the KNX
2. Configure the dimmer switch using a computer and the ETS5 software.
• Assign each dimmer switch to an RF line medium. The ETS software will automatically assign a domain address that identifies the KNX
Up to 256 KNX ® RF devices can be configured for one KNX
will always end with 0 (x.x.0) and can never be 0.0.0
• The software will assign a group address, a set of communication objects and corresponding parameters to each dimmer switch.
4
The Niko dimmer switch can be configured with three communication objects via the ETS5 software:
- single channels
- dimming
- shutter
Communication objects 'dimming' and 'shutter' define the parameters and related actions (top and bottom contacts combined). The communication object 'single channels' configures the parameters for each
individual contact (see the below overview of the KNX
EN
To be ordered separately
+
energy bows
ETS5 software. You can configure each button as a switch, a dimmer control, a roller shutter control or as a scene selector.
®
dimmer switch on www.niko.eu/article/360-31001.
®
® RF line, including one KNX
® dimmer switch communication objects and paramaters).
e
media coupler 360-33001 (to be ordered separately) to capture the wireless telegrams and convert them to
®
dimmer switch follow the steps outlined below:
®
® media coupler (360-33001). The physical address of the media coupler
To be ordered separately
RF line.
®
PM360-31001_EN