Niko 360-31001 Mode D'emploi page 10

360-31001
7.1. Materials and obstructions
Material
Wood, plaster, uncoated, without metal
Brick, concrete without iron, chipboard
Ferroconcrete, hollow lightweight walls filled with insulating wool on metal foil, metallic heating insulation
sheets, metallic surfaces, glass with a metal coating, floor heating systems, metal flush surround plates
7.2. Position
Avoid installing the wireless dimmer switch:
• in a narrow room with thick walls
• on the same wall as a receiver (wireless KNX
• close to the ground
• on a metal or moist surface or in a damp environment
• in so-called 'dead spots', caused by radio reflections from nearby conductive materials or large obstacles
7.3. Sources of interference
Respect a minimum distance between the devices listed below and the KNX
Devices
Magnets and ferromagnetic materials
Low-power electronic devices (e.g. DECT telephones, smartphones, WLAN routers, analog radios, electronic
ballasts, controllers, TVs or computers)
Take into account that a high-power electronic device in a building can interfere with the radiotelegrams of the Niko dimmer switch. This could even happen in well-functioning installations with a direct line-of-sight or a distance
less than 30 m between the switch and the receiver. Identify the interfering source and remove it. When removal is not possible, consider relocating the Niko dimmer switch or use a KNX
8. SPECIFICATIONS
Article number
Power supply
Operating force
RF Protocol
Modulation / Data rate
Mounting method
Mounting height
Weight
Temperature (storage / operating)
Dimensions with Niko Original or Niko Pure flush surround plate (HxWxD)
Dimensions with Niko Intense flush surround plate (HxWxD)
Protection degree
Operating frequency
Antenna
Maximum range (indoor from switch to receiver)
Maximum RF power
Marking
* The typical max. temperature difference between the Niko dimmer switch (TX) and a receiver (RX) should not exceed 40° C.
** The maximum range depends on the indoor environment. Read the RF planning guide in this manual.
10
EN
® media coupler 360-33001)
® dimmer switch.
Range Reduction (versus a direct line of sight)
5 – 20%
20 – 40%
40 – 90%
Minimum distance
6 cm
50 cm
360-31001
Integrated kinetic energy harvester
Typically 10 N (at room temperature)
KNX RF1.R S-Mode
Frequency-shift keying (FSK) / up to 16.384 kbps
Wall mounting
110 cm
22 g ±1 g
-20 up to +45 °C *
83 x 83 x 15 mm
85 x 85 x 15 mm
IP20
868,300 MHz
Integrated antenna
Up to 30 m **
-2 dBm / 0,63 mW
CE
® RF repeater (max. 2).
PM360-31001_EN