Safety Cautions - Gima Gimette 1,5 Mode D'emploi

For a correct use do not fill the tray up excessively; it will allow a good circulation of hot air.
When the required temperature is reached, the sterilization times vary from min.30 minutes up to
max.60 minutes with temperature 150÷180°C max. according to the material.
Do not keep the thermostat highest temperature for a long time, in order not to risk of spoiling the
sterilized material.
The lighting up of the red light (nr.5) "Alarm" indicates the temperature is going over 220°C and the
second safety thermostat is working limiting the temperature.
Let the service or the specialized technician verify the efficiency of the regulator thermostat.
Maintenance and repair
Always check the power is unplugged before maintenance is carried out. The sterilizer needs no particular
maintenance, provided the adequate environment are satisfied, except for a regular cleaning of its
external parts.
It is recommended to clean the equipment with a soft cloth and water. Do not use acids or solvents.
Regularly check if the power cable is in good conditions. It is possible to replace the safety fuse pulling
out the fuse block at the rear under the socket. Please always follow the characteristics stated in the
technical data sheet. If the sterilizer doesn't work properly, contact the manufacturer or the authorized
service. If any repairs are needed, please return the equipment directly to the manufacturer or to the
local distributor using only the original package. However it is possible to contact specialized technicians,
who must work in accordance to general safety and accident prevention rules of the country in which
the equipment is installed.
Out of order
No particolar cautions.
This equipment must be used only by authorized personnel thoroughly familiar with the correct use.
The sterilizer must be used only for its designed purpose:
to sterilizer surgical instruments or tools in the medical and paramedical field. The sterilizer
must not be used for all treatments concerning contact lenses (Rule 15 - All.9 - Comma 1).
It is necessary to take all precautions to avoid unauthorized use.
Do not modify, change or put out of order any electrical or thermal safety protection of the equipment.
When the sterilizer is operating, pay attention to the people near the equipment.
The user must not attempt to carry out any repair unless authorized.
Do not clean or repair the sterilizer while it is connected to an electrical system and be sure the sterilization
chamber is at room temperature. Regularly check if the power cable is damaged.
When authorized technicians decide to replace spare parts, they must use original replacements and
moreover they must adhere to the manufacturer's information and technical characteristics. In case of
any doubt about safety rules, please contact the manufacturer or local distributor before using the
equipment.
However use the sterilizer in accordance with the general safety and accident prevention rules of the
country in which the equipment is installed.
ATTENTION!
Avoid to use the sterilizer in an environment where the explosive gases may be present.

SAFETY CAUTIONS

8