Hose Connection - Speedaire 25F538 Manuel D'instructions

Operating Instuctions & Parts Manual
Speedaire 2 GALLON
Oilless Air Compressor

HOSE CONNECTION

TO PREVENT EXPLOSION
Use only clean, dry, regulated,
compressed air to power this
tool.Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled gas
as a power source for this tool.
Male
Connector
Tool
Quick
Coupler
Valve Filter
Oiler
Compressor
Quick
Coupler
Regulator with
Pressure Gauge
Recommended Air Line Components
1. Incorporate an in-line oiler,
shut-off valve, regulator with
pressure gauge, and filter for
best service, as shown in the
diagram above. An in-line
shutoff valve is an important
safety device because it con-
trols the air supply even if the
air hose is ruptured.
NOTE:
If an automatic oiler
system is not used, add a few
drops of Pneumatic Tool Oil to
the airline connection before
operation. Add a few more
drops after each hour of
continual use.
®
2. Attach an air hose to the
compressor's air outlet.
Connect the air hose to the
air inlet of the tool.
3. Other components, such
as a connector and quick
coupler, will make operation
more efficient, but are not
required.
TO PREVENT SERIOUS
INJURY FROM ACCIDENTAL
OPERATION:
Male
Connector
Do not install a female quick
coupler on the tool. Such a
coupler contains an air valve
Air Hose
that will allow the air tool to
on Reel
retain pressure and operate
accidentally after the air
supply is disconnected.
Air
OPERATING
INSTRUCTIONS
To Start The Compressor:
1. Check to make sure the
Air Tank's Drain Valve,
located at the bottom of the
Air Tank , is fully closed. Pull
on the Safety Valve to verify
that it is not stuck. (See
Figures B and C.)
2. Plug the Power Cord into
the nearest 120 volt,
grounded, electrical outlet.
3. Push in the "ON" side of
the ON/OFF Power Switch to
turn the compressor on.
(See Figure B.)
Regulated
Pressure
Gauge
To Adjust The Air Regulator:
1. Connect a high pressure
air hose (not included) to
the Pressure Regulator .
Connect an air blow gun
(not included) to the other
end of the air hose. Turn the
Figure B
compressor on. Refer to
Hose Connection Instructions
ON/OFF
on page 5.
Power Switch
2. When the maximum air
pressure, 100 PSI, is reached
as indicated by the Tank
Pressure Gauge , the motor
will stop.
Drain alve
V
5
25F538
Figure C
Pressure Safety Tank
Regulator Valve Pressure
Gauge
E
N
G
L
I
S
H