Suntec Wellness KLIMATRONIC Heat Ray Carbon 3000 outdoor Mode D'emploi page 11

Operating
1. Plug the power cord into the outlet.
2. Click rocker switch to ▬ position and press Open/Close once, the digital screen shows P.0 which means power on.
3. Press Open/Close twice, the digital screen shows P.1 which means first power setting.
4. Press Open/Close 3 times, the digital screen shows P.2 which means second power setting.
5. Press Open/Close 4 times, the digital screen shows P.3 which means second power setting.
6. After the function is on, 1-24 hours timing shutdown can be adjusted. The digital screen showing 01 indicates timing
one hour, 02 indicates timing two hours, etc.
Assembly (1.)
1. Loosen the base nut (turn)
2. Please mount the feet on the base
3. Please attach the telescopic pole to the base.
4. Fasten the base nut (turn) to connect the pole to the base.
5. Loosen the connection cover on the pole (turn).
6. Adjust to the desired height and reattach the connection cover (turn).
7. Mount the brackets on the back of the heater using the enclosed screws (M5*10m screws).
8. Please adjust the brackets with the correct distance (approx. 4cm).
9. Loosen the screw fastening at the top end of the telescopic rod.
10. Please place the upper end of the rod between the brackets on the back of the heater and connect the two parts
with the screw fastening.
Remote control
Definition of the buttons on the remote control
The functions of the appliance may be controlled via the buttons on your remote control and LCD screen. You may also
control some of the functions of your heater through the
1000W: First heating level. After turning on the appliance, you can choose low heating level.
2000W: Second heating level. After turning on the appliance, you can choose moderate
heating level.
3000W: Third heating level. After turn on the appliance, you can choose high heating level.
Timer. After the function is on, 1-24 hours timing shutdown can be adjusted. The digital screen
showing 01 means one hour, 02 means two hours, etc
Warning! Please insert the battery in your remote control.
Insert batteries
Turn the remote control onto the back and pull out battery cover.
Insert the batterie in accordance with the instructions and polarity (+/-) of the battery
−
Insert a CR2025 type battery into your remote control.
−
Change the battery in the same way depicted above
−
Warning:
Please use the battery type indicated in this manual. Improper or incorrect use of batteries may cause corrosion or battery
leakage, which could cause personal injury or damage to property
Maintenance and care
Maintenance
Attention! Careful and regular maintenance of infrared heater is required to attain a long and efficient operation of your
appliance.
1. Check the cleanliness of the reflector and IR-filament at least once a month. If necessary, apply cleaning and maintenance
instructions.
buttons on the front side of the heater.
.
.
.
11