Suntec Wellness KLIMATRONIC Heat Ray Carbon 3000 outdoor Mode D'emploi page 10

• Never use the appliance with wet hands.
• Do not insert any objects into the appliance as this may
cause electric shocks, fire or damages to the appliance.
• Do not place the heater under or near curtains, drapes and
other flammable materials as well as walls or other
objects.
• Never immerse the appliance, it's cord and plug into water
or other liquids.
• There is a risk of tipping over when there is increased
wind, please never set up the device unsupervised in
areas that are not protected from the wind.
Warning:
cover the heater!
Installation
1. There are 4 brackets and fasteners inside the packaging which are to be used for the installation. Furthermore, in the
canal of back side of the appliance there are 4 square fastener washers 25×25mm. Take the square washers and fasten
2 brackets to the canal on the backside of the heater using the screws.
2. Fasten the brackets at the appropriate distance of each other (45-55cm).
Two other brackets are to be fastened using the fasteners at the appropriate distance on the wall parallel to the
floor (At least 1.8 m from the floor and at least 0.5 m from the ceiling).
4. Join the brackets on the appliance with the brackets, fastened on the wall, with the help of figured screw-nuts. Install
the heater under necessary angle (in the direction to the area being heated).
Install the appliance strict in horizontal position only.
Safety Distances: Minimum distances required for safety
Minimum distances from wall corners: 40cm
Minimum distances from coverage area and other objects: 100cm
Right and wrong positions
Direct your appliance towards the most appropriate angle.
Do face the unit to the window, glasses etc. as the heater primarily heats the locations onto which its light falls. Prevent the
loss of directed heat through the windows.
In order to avoid overheating, do not
10