Mantion SLID UP M300 Notice De Pose page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Disabling a switch:
1. Press and hold down the setup button for roughly 5 seconds.
The LED comes on (the card is in "radio peering" mode).
2. Press and release the setup button.
The LED flashes slowly (card in "radio suppression" mode).
3. While the LED is flashing, press "open" and "close" simultaneously on the switch.
The LED flashes quickly then goes out: the button has been disabled.
Disabling a remote control:
1. Press and hold down the setup button for roughly 5 seconds.
The LED comes on (the card is in "radio peering" mode).
2. Press and release the setup button.
The LED flashes slowly (card in "radio suppression" mode).
3. While the LED is flashing, press the "open" and "close" buttons simultaneously for the desired
channel on the remote control.
The LED flashes quickly then goes out: the remote control has been disabled.
Disabling all transmitters (switches, remote control...):
1. Press and hold down the setup button for roughly 5 seconds.
The LED comes on.
2. Press and hold down the setup button for roughly 5 seconds.
The LED goes out then flashes quickly: all switches have been disabled and settings are reset
to default values.
Other information:
When the board is ready to receive a radio ID code (light on steady – record – or flashing slowly –
disable), the LED will go out after 20 seconds of inactivity: the board has reverted to its normal
operating mode and you will need to start the procedure from the beginning again.
When the product is in "radio disable" mode, a short press on the setup button will turn off the LED,
and the product will revert to normal operating mode.
27

Publicité

Table des Matières
loading

Table des Matières