Mantion SLID UP M300 Notice De Pose page 22

Before bringing into service this product, check you can move the doors manually effortless.
A bad installation with a bad doors alignment or high frictions can damage the motors.
BP prog
Stoppers apprenticeship
This product is equipped with an apprenticeship push button (BP prog) which determines the
movement of each door.
The motors won't work as the apprenticeship has not been carried out.
Operation directions:
5) Put switches to the OFF position.
6) Switch power supply on.
7) If you want to use a radio product, refer to the wireless setup instructions.
8) To start the learning cycle, short press on BP prog.
cycle: closing – opening - closing in slow speed.
st
1
cycle: opening – closing in normal speed.
nd
2
Note: If, after carrying out the learning cycle, the door is open instead of close, put the switch 3 in
ON position and do another learning.
22
Bringing into service