Mantion SLID UP M300 Notice De Pose page 16

WARNING: IMPORTANT SAFETY INSTRUCTIONS.
Those instructions must be followed in the interest of personal safety; Keep those
instructions.
WIDOOR INSIDE is exclusively designed for opening and closing sliding internal doors. It must not
be used for any purpose other than that specified in these instructions. The manufacturer or supplier
shall not be liable for any damage resulting from improper use thereof. The user alone shall be solely
liable and assume any risks arising from improper use of the product.
This door motor must be installed by persons fully aware of the hazards involved in currents, who
have the requisite qualifications to work on domestic installations in accordance with good practice.
Follow all the instructions because faulty installation can cause injury.
The assembly steps must be followed, as must the operating instructions, and safety rules must
always be heeded.
Before installing the door motor, check that both the driven part are in good physical condition and
the structure has the necessary load-bearing capacity for our product in its entirety.
The electrical installation must be done according to prevailing national standards and in accordance
with all legal obligations and/or prevailing obligations to that effect.
(Electrical compatibility: voltage and frequency as marked on the product and that of the power
network where it will be used.) Do not connect the device without first checking that the control circuit
is dead.
Check the installation frequently to detect any imbalances or signs of wear or damage. Do not use
the device if it needs repairing or adjusting.
Disconnect the power supply when cleaning it or carrying out other maintenance or servicing tasks.
Never modify or fit any additional parts to the device that may compromise safety without MANTION
SMT's written permission.
The user alone is solely and entirely responsible for any breach of these safety rules, and any
damage resulting there from.
The product must be stored indoors in a dry place at a temperature of between 0 °C and +60 °C.
When fitting it, the installation engineer must heed accident prevention instructions and the
standards in force in the country.
Do not immerse the gear motor in water or splash it.
Do not dispose of it in fire or bring it into contact with flame or any heat source.
Do not use household products or chemicals to clean it.
Do not dispose of the packaging in the environment; treat waste according to the standards in force
in the country.
Keep products, devices and documentation out of reach of children.
Do not let children play with the fixed control devices. Keep remote controls out of reach of children.
The manufacturer or supplier shall not be liable for any damage resulting from any other use of the
product. If replacing the product, only use MANTION SMT or MANTION SMT-approved products.
16
E
N