Mantion SLID UP M300 Notice De Pose page 29

Symptoms
The motor doesn't work.
The motor closes when we
request it to open.
The door opens after a
closure.
The door stays open
The apprenticeship is carried
out and the door is not
opening on a wired
command (button).
The apprenticeship is done
and the door is not opening
on a radio command.
The door opens hardly.
Drive is noisy (clicking
noise).
Diagnostic aid
Probable causes
Connection problem to the
power supply.
Learning not done.
Put the motor in the other way.
There is an obstacle.
Learning problem.
Bad alignment of the doors
The fixation piece of the belt is
not enough tight.
Wrong connection to the
command.
Learning problem.
Defective battery.
Learning problem.
Peering of the radio control not
carried out.
Wrong mounting of the door.
Motor speed is low.
The belt is slack.
Solutions
Check the connection of the
control box to power supply.
Do a learning.
Turn ON the switch 3, and do
another learning.
Remove the obstacle.
Do another learning.
Do another learning and check
the doors alignment
Tighten the fixation piece.
Check the connection to the
command.
Do another learning.
Check and change if necessary
the command battery.
Do another learning.
Do a peering of the command
(see wireless setup
instructions).
Check the mounting of the
door.
The door must to be able to
move manually easily.
Adjust door speed thanks to
settings buttons (see settings
instructions).
Tighten the belt.
29