Troubleshooting - Magmaweld proSTICK 200i Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

20
Maintenance and Service

4.2 Troubleshooting

The following tables contain possible errors to be encountered and their solutions.
EN
Error
Machine does not work at all
The machine welds poorly
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• Make sure that the machine is connected to power
• Check that the mains connections are correct
• Check the mains power supply fuses, mains cable and its plug
• Check the on / off operating switch
• If you have made all the checks and if the problem still persists, please
contact the authorized service center
• Make sure that the machine's grounding pliers are connected to the
workpiece
• Make sure that the cables are secure and that the connection points are
not worn
• Make sure that the parameter and process selection are correct
• According to the process you have chosen, follow the steps below:
1- Check the pole that the electrode must be connected and the
current value that must be set on the machine
2- Check that the gas flow is open, ensuring that the flow is accurate
3- Make sure that the tungsten tip is clean
4- Make sure the durableness of the welding torch
5- If you have made all the checks, if the problem still persists, please
contact the authorized service center
Solution
www.magmaweld.com
proSTICK 200i

Publicité

Table des Matières
loading

Table des Matières