R&G LP0206BK Instructions De Montage page 6


Take the indicator bracket assembly and position it below the cover plate with both 5mm holes
being aligned as shown in Picture 11. Secure the assembly using M5 bolts (Item 12) with M5
washers (Item 6) and M5 nyloc nuts (Item 5) from the kit. Tighten the nuts to 12Nm.

Apply a thin layer of grease onto the surface of each spacer (Item 3) provided in the kit. Place
each spacer over the 8mm hole on the licence plate bracket (Item 4). Shown in Picture 12. The
grease is used to keep the spacers in place while fitting.

Offer the whole tail tidy assembly towards the subframe of the bike with all the wires being
positioned in the slot provided (shown in Picture 13). Locate the wires around the subframe as
original.

Secure the assembly using the M8 bolts (Item 10) with M8 washers (Item 2) and M8 nyloc
nuts (Item 1) as shown in Picture 14. Tighten the nuts to 20Nm.

Take the OEM subharness that was removed earlier, in order to install R&G licence plate
illuminator, the OEM wiring needs to be 'cut and shut'. Cut the OEM licence plate illuminator
wiring at least 20mm away from its bulb holder (Shown in Picture 15). Peel the end of both
wires and crimp female bullet connectors (Item 13) from the kit. Plug in the licence plate
illuminator connectors in this scheme:
If licence plate illuminator fails to illuminate, please swap the connectors over.

If using LP0206BK, reconnect the indicator connectors as original.

Reconnect the main square subharness connector to the main OEM harness as original. Tuck
in all the wiring in an appropriated location and tidy up using the cable ties (Item 14) provided.

It is recommended to have the bike running and test all the lights at this stage.

Refit licence plate as original (it may require drilling)

IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR
DOWN ON THE LICENCE PLATE HANGER, THERE IS A SMALL CHANCE OF THE
LICENCE PLATE HITTING THE BACK WHEEL UNDER HEAVY LOAD AND OVER
LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK FOR THIS
POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK THIS COULD
RESULT IN SERIOUS INJURY.

Depending on local laws, attach the red reflector in an appropriate location.

Refit seat.

Test both indicator lights and licence plate illuminator before riding.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its
particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify any
fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301

Subharness YELLOW ------------ Licence Plate Illuminator RED

Subharness GREEN --------------- Licence Plate Illuminator BLACK
ISSUE 1 26/07/2016 (HH)
CONSUMER NOTICE
R&G Racing
www.rg-racing.com Email: info@rg-racing.com