Vacuum Set Up And Operation; Filter Installation And Maintenance; Filtration System; Dry Pick Up Operation - Shop-Vac SSP16 Serie Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. If your tool holder looks like the one shown to the right, assemble as follows:
a. Set tank cover onto the tank. Position back of tank facing you.
b. Take tool holder and slide over notches located on rear of tank. Continue to step 3.
3. Remove tank cover from tank and refer to the set up and operation section.

VACUUM SET UP AND OPERATION

DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
normal dry or wet pick up operation based on your cleaning needs. To use the pump feature, refer to the
pump set up and operation section.
2. Replace tank cover and apply pressure with thumb to each latch until it snaps tightly into place. Make
sure each latch is clamped securely.
3. Insert machine hose end into inlet located on the front of the tank. Twist slightly to
tighten the connection.
4. Attach the desired cleaning accessory onto the accessory end of the hose. NOTE: Many more useful tools
are available at your local dealer or the Shop-Vac
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF

FILTER INSTALLATION AND MAINTENANCE

FILTRATION SYSTEM

There are a variety of filters available for your vacuum. There are cage filters that install onto the underside
of the tank cover and tank filters that install into the tank. The filters are grouped into three filtration
categories. General filtration is used for large debris; such as, wood chips, nails and gravel. Medium
filtration is used for medium debris; such as, dirt, sand and sawdust. Fine filtration is used for fine debris;
such as drywall dust, cold ash and cement dust. It is important to have the correct filters installed for your
cleaning operation to protect your vacuum motor. THE MOST EFFICIENT FILTRATION FOR YOUR VACUUM IS A
FINE FILTRATION CAGE FILTER WITH A FINE FILTRATION TANK FILTER.
NOTE: When using the vacuum to pick up very fine dust. It will be necessary to empty the tank and clean
the cage filter at more frequent intervals to maintain maximum pick up power or add a disposable filter bag.

DRY PICK UP OPERATION

NOTE: Never use the vacuum for dry pick up without a dry use filter installed. Using the vacuum without a
filter will cause dust to discharge from the blower port and cause damage to the motor.
WARNING
BEFORE REMOVING THE TANK COVER.
PAGE 6
ASSEMBLY (CONT'D.)
This equipment incorporates parts such as switches, motors or the
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET
website.
®

Publicité

Table des Matières

Dépannage

loading

Table des Matières