Tool Holder - Shop-Vac 92 Serie Manuel D'utilisation

6. Take caster foot marked with the letter A and place in slot on left front of tank
also marked with letter A. Secure with screw provided.
7. Take caster foot marked with the letter B and place in slot on right front of tank also
marked with the letter B. Secure with screw provided.
8. If flat washers are included in hardware package place flat washer over
stem of caster before installing casters into feet. NOTE: Flat washers are not
required with all units.
9. Insert casters into feet by placing stem of caster into holes provided.
Apply pressure and twisting motion until casters snap into place. Return
tank to upright position.
CARRIAGE HANDLE
If your vacuum comes with a carriage handle, assemble as follows:
1. Stand tank in the upright position. Spread ends of carriage
handle (to prevent damage to tank) while placing them
under the side tank handles.
2. Align holes in carriage handle with holes in tank. Fasten
tightly with screws, washers and nuts provided. The rubber
side of the washers must be placed against the inside wall
of the tank to prevent leakage or loss of performance.

TOOL HOLDER

(Not standard with all models)
If your unit came with a tool holder, assemble as follows:
1. Set tank cover onto the tank. Position with back of tank cover facing you.
2. Press tabs of tool holder into the slots on mounting
lugs, located on back of tank cover.
3. Press down until tabs snap into place. Remove tank cover from tank and refer to the
set up and operation section.
PAGE 8
ASSEMBLY (CONT'D.)