King gates JETXL Mode D'emploi page 19

Before it can be fixed to the wall, the bracket must be welded to
the fastening plate (Fig. 3); the bracket may be cut to the desired
length, adjusting distances A and E accordingly
FIG.3
NOTE - The bracket supplied with the gearmotor is 180 mm
long
m
WARNING! Before fixing the rear bracket, make sure
that the front bracket will be fixed to a solid position of
the gate leaf; the front bracket will have to be secured at a
different height than the rear bracket (Fig. 4).
FIG.4
Fix the bracket in place using suitable plugs, screws and washers
(not supplied)
INSTALLATION OF THE FRONT FIXING
BRACKET
1. For the installation of the front bracket to the gate leaf, refer
to distance D (fig. 2).
2. Define the front bracket installation height in accordance with
fig. 4.
3. Fix the bracket to the solid section of the gate leaf.
SECURING THE GEARMOTOR TO THE
FIXING BRACKETS
1. Secure the gearmotor to the rear bracket:
NOTE: if the rear bracket is not completely level, the
back tilting section can help compensate for any axis
misalignments between the two brackets (+/-5°).
FIG.5
+ 5°
- 5°
2. Secure the gearmotor to the bracket as shown in fig. 6, using
the screw, washer and nut supplied;
3. Fully tighten the nut and then loosen it again by approximately
1/10 of a turn, to allow a minimum clearance between the
parts.
FIG.6
1
2
17