Work Area; Personal Safety - Power Fist 8408890 Mode D'emploi

8408890

WORK AREA

1. Operate in a safe work environment. Keep your work area clean and well lit.
2. Do not install in the presence of flammable gases or liquids.
3. Keep anyone not wearing the appropriate safety equipment away from the work area.
4. Always lock up tools and keep them out of the reach of children.
NOTE: Minimize distractions in the work environment. Distractions can cause you to lose control of the tool.

PERSONAL SAFETY

CAUTION! Wear protective equipment approved by the Canadian Standards Association (CSA) or American
National Standards Institute (ANSI) when using the tool.
1. Dress properly, wear protective equipment. Use breathing, ear, eye, face, foot, hand and head protection.
Always wear ANSI approved impact safety goggles, which must provide both frontal and side protection.
Protect your hands with suitable gloves. Protect your head from falling objects by wearing a hard hat.
Wear an ANSI approved dust mask or respirator when working around chemical dusts and mists. Wear
ANSI approved earplugs. Protective, electrically non-conductive clothes and non-skid footwear are
recommended when working. Wear steel-toed boots to prevent injury from falling objects.
2. Control the machine, personal movement and the work environment to avoid personal injury or damage to
the machine. Stay alert, watch what you are doing and use your common sense.
3. Keep articles of clothing, jewelry, hair, etc., away from moving parts to avoid entanglement with a tool.
4. Do not operate any machine / tool when tired or under the influence of drugs, alcohol or medications.
5. Do not overreach when operating a tool. Proper footing and balance enables better control in
unexpected situations.
SPECIFIC SAFETY PRECAUTIONS
1. Running the engine gives off carbon monoxide, an odourless, colourless, poison gas. Breathing carbon
monoxide can cause headache, fatigue, dizziness, vomiting, confusion, seizures, nausea, fainting or death.
a. Operate the water pump outdoors only.
b. Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes,
or other openings.
c. Do not start or run the engine indoors or in an enclosed area, even if windows and doors are open.
2. Use of the water pump can create puddles and slippery surfaces.
a. Operate the water pump on a level, stable surface.
b. The area should have adequate slopes and drainage to reduce the possibility of a fall due to
slippery surfaces.
3. Unintentional sparking can result in fire or electric shock.
a. When adjusting or making repairs to your water pump, disconnect the spark plug wire from the spark
plug and place the wire where it cannot contact the spark plug.
b. When testing for engine spark, use an approved spark tester and do not check for spark with the spark
plug removed.
4. When adding or draining fuel:
a. Turn the water pump OFF and let it cool at least two minutes before removing the fuel cap. Loosen the
cap slowly to relieve pressure in the tank.
b. Fill or drain the fuel tank outdoors.
c. Do not overfill the tank. Allow space for fuel expansion.
d. If fuel spills, wait until it evaporates before starting the engine.
e. Keep the fuel away from sparks, open flames, pilot lights, cigars, cigarettes, pipes, heat and other
ignition sources.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
2 in. High Pressure Transfer Pump
V 3.03
3