Important Notice - Pentair MAGICSTREAM DECKJET I Guide De L'installation

page de 8

/ 8
Signets

Les langues disponibles

This Product should be installed and serviced by a professional pool/spa technician. The procedures in this manual must be

followed exactly. Improper installation and/or operation will void the warranty. Before installing this product, read and follow

all warning notices and instructions accompanying this product. If you have application questions or would like additional

copies of these instructions, please visit www.pentairpooleurope.com.

Attention Installer. This manual contains important information about the installation, operation and safe use of this product. This

information should be given to the owner/operator of this equipment.

Thank you for your purchase of the Pentair Deck Jet I. This innovative water effect is designed to be cast into the concrete deck or gunite sidewall of a

swimming pool. It can also be mounted through the sidewall of a vinyl liner in-ground or above ground pool. It is furnished with five water effect eyeballs,

one of which you will install in the body after the pool is complete.

It is recommended that you supply the Deck Jet with filtered water. Also, if more than one Deck Jet is used on this pool, we recommend that a PVC ball valve

be used to control the flow to EACH effect. This is because the flow and pressure requirements are so low that any difference in water pressure caused by

piping length will be noticed.

The supply piping to the Deck Jet can be any size. The connection on the bottom of the body is 1 1/2" or 50mm slip (when using the adaptor that is included).

If the Pentair Deck Jet is to be mounted into concrete or gunite:

1. Place the plastic parts bag in a safe location. This contains all the parts you will need to activate the

water effects after the pool hardscape is complete.

2. Leave the red gunite shield pressed securely in the body to prevent contamination of the internal

threads.

3. You will need to adapt your supply piping to the 1 1/2" or 50mm PVC slip connection with a reducing

bushing. Glue the bushing to the body.

4. Glue the supply piping to the bushing.

5. Secure the body to prevent movement during the gunite/concrete placement. You can drill holes in the

horizontal flange and wire the body to the rebar. Because the Deck Jet is round, you can orient it in any

direction.

6. The top flange of the shield plug should be flush with the FINAL prepared surface.

If the Pentair Deck Jet is to be mounted into the sidewall of a vinyl lined pool:

Place the plastic parts bag in a safe location. This contains all the parts you will need to

activate the water effects after the pool hardscape is complete.

Cut a 6 cm (2-3/8") diameter hole, above water level, at the location desired.

Put a gasket on the body and insert the body through the hole from the outside.

Put on the remaining gasket, friction ring, and nut. Tighten the nut until the gasket is

compressed slightly. All threads on the nut should be engaged, but it is recommended

that the body not stick out of the nut too far. If desired, a bead of silicone caulking can

be applied to better seal the pool wall.

You will need to adapt your supply piping to the 1½" or 50mm PVC slip connection with

a reducing bushing.

Glue the supply piping to the bushing.

Support the piping on the outside of pool to prevent potential pipe breakage.

LIMITED WARRANTY: 2 YEARS

Trademarks and Disclaimers. The Pentair logo is a trademark of Pentair. Other trademarks and trade names may be used in this document to refer to either the entities

claiming the marks and names or their products. Pentair disclaims any proprietary interest in trademarks and trade names other than its own.

Deck Jet I (580000-EU)

CAUTION