Maintaining Your Label Printer; Print Head Maintenance; Roller Maintenance; Label Outlet Maintenance - Pitney Bowes SendKit Guide D'installation

Federal Communications Commission (FCC) Declaration of Conformity (For US Only)
Product Name: Label Printer QL-1050
Model Number: QL-1050
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1 - this device may not cause harmful interference, and
2 - this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

Maintaining Your Label Printer

1 Print Head Maintenance

The DK Roll used with label printer is designed to clean the print head automatically. When the
DK Roll passes the print head during printing and label feeding, it cleans the print head. If despite
this action the print head is not cleaned thoroughly then use a cotton swab to wipe the print head.

2 Roller Maintenance

Cut the DK label and remove the backing paper of the label. Then, put
the adhesive side of the label against the roller and remove the dirt.

3 Label Outlet Maintenance

If glue accumulates on the label outlet and label printer becomes jammed, disconnect the power
plug from label printer and clean the label outlet with a cloth dipped in isopropyl alcohol.
Operator Guide / Guide d'utilisation
Pitney Bowes
Responsible Party
Name:
Address:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Important:
• The enclosed interface cable should be used in order to ensure
compliance with the limits for a Class B digital device.
• A shielded interface cable should be used in order to ensure
compliance with the limits for a Class B digital device.
• Changes or modifications not expressly approved by Brother Industries, Ltd.
could void the user's authority to operate the equipment.
(English) Label Printer
Pitney Bowes, Inc.
3001 Summer St.
Stamford, CT 06926
2
1
3
8 / 20