General Precautions - Pitney Bowes SendKit Guide D'installation

Caution
This section contains important information about using your label printer and its labels.
Installation/Storage
• Put the label printer on a flat, stable surface such as a desk.
DK Roll
• Be careful not to drop the DK Roll.
• DK Rolls use thermal paper and thermal film. Both the label and print will
fade with sunlight and heat. Do not use DK Rolls for outdoor use that
requires durability.

General Precautions

The Label Printer
• The label printer is a precision machine. Do not drop, hit or otherwise bang it.
• The machine may malfunction if left near a television, radio, etc. Do not use
label printer near any device that can cause electromagnetic interference.
• Do not insert any objects into or block the label output slot, USB port, Serial
port or LAN port.
DK Rolls
• Use only genuine Brother accessories and supplies (with
use any unauthorized accessories or supplies.
• If the label is attached to a wet, dirty, or oily surface, it may peel off easily.
Before applying the label, clean the surface to which the label will be applied.
• DK Rolls use thermal paper and thermal film, so ultraviolet rays, wind, and
rain may cause the color of the label to fade and the ends of the label to peel
off.
• Do not expose the DK Rolls to direct sunlight, high temperatures, high
humidity, or dust. Store in a cool, dark place. Use the DK Rolls soon after
opening the package.
• Scratching the printed surface of the label with your finger nails or metal
objects, or touching the printed surface with hands dampened by water,
Pitney Bowes Operator Guide / Guide d'utilisation
• Do not put any heavy objects on top of the label printer.
• Depending on the area, material, and environmental conditions, the
label may unpeel or become irremovable; or the color of the label may
change or be transferred to other objects. Before applying the label,
test the label by affixing a small piece of it to an inconspicuous area of
the intended surface.
• Use only the USB Interface Cable included with label printer.
• When not in use for an extended period, remove the DK Roll from
label printer.
• Do not attempt to print labels while the DK Roll cover is open.
sweat, or medicated cream, etc., can cause the label's color to
mark). Do not
change or fade.
• Do not apply labels to any persons, animals, or plants.
• The end of the DK Roll is designed to not adhere to the label spool,
so the last label may not be cut properly. If this happens, remove the
remaining labels, insert a new DK Roll, and reprint the last label.
Note: To account for this, the number of DK Labels included on each
DK Roll may be more than indicated on the package.
• If a label is removed after being applied to a surface, some portion of
the label may remain. Remove the remaining portion before attaching
a new label.
• Some DK Rolls use permanent adhesive for their labels. These labels
cannot be easily peeled off once attached.
(English) Label Printer
7 / 20