Troubleshooting - Pitney Bowes SendKit Guide D'installation

Troubleshooting

Problem
No display
Lo or low battery displayed
CAL is displayed
Negative number is displayed
ErrE is displayed
Display reads 0.0 with an item
on the platform
Pitney Bowes Operator Guide / Guide d'utilisation
Solution
Ensure the scale is connected to the computer using the cable, or replace the battery.
If not connected to the computer, press the Power button.
Replace the 9-volt battery.
The scale is in calibration mode. Press the Power button to return to normal mode.
A negative number is displayed when there is no weight on the scale.
Press Zero to reset the scale to zero.
The item on the scale platform exceeds the maximum capacity of the scale.
Remove the item immediately to prevent damage to the scale.
Remove the item from the platform. Then press the Zero button to return
the display to 0.0 so that you can continue weighing items.
(English) Scale
5 / 20