Westfalia 321 702 300 107 Instructions De Montage page 15

Installation Instructions:
Electrical System for Towing Hitch
Installing the electrical kit
1. Disconnect the battery.
2. Remove the following covers and panels, if necessary:
Interior
•
Panel underneath the steering column
-
Unscrew relay of equipment rack
-
Unscrew fuse box
-
Panel of transmission tunnel / hand brake lever
-
Mounting the socket
3. Insert the micro switch housing and the contact insert through the hole in the towbar cross
tube or the socket bracket (Fig. 1/1) and press them into the supplied socket housing.
4. Fasten the socket with the two supplied screws to the cross tube or the socket bracket (Fig.
1/1).
Installing the electrical kit
5. Connect / engage the two cable ends with the 14-pin connectors and fasten at the designated
point at the back of the cargo plate (Fig. 1/2).
6. Remove the cable ties with that the cable is fastened to the tucker bolt for the license plate
illumination (Fig. 1/10).
7. Use the supplied cable ties (with holder) to connect the cable loom and the cable for the
license plate illumination and fasten with the holder to the tucker bolt. (Fig. 1/10).
8. Connect the brown cables with the ring terminal to the ground point on the vehicle (Fig. 1/3) at
the cargo plate.
9. Install the 9-wire cable harness along the cable looms on the vehicle to the 42-pin coupling
point on the chassis (Fig. 1/4).
10. Unlock and pull apart the 42-pin plug-type connection on the vehicle.
11. Remove the dummy plugs out of the chambers indicated below and engage the individual
cables from the two 9-wire cable looms in the two connectors as follows:
VW Amarok
All manuals and user guides at all-guides.com
321 702 391 101 - 003- 27/11
15