Table des Matières
Publicité
Ixengo L 230V RTS
Any use of this product outside the field of application
described in these instructions is prohibited (see "Field of
application" paragraph in the installation manual).
The use of any accessories or components not
recommended by Somfy is prohibited, as personal safety
cannot be guaranteed.
Somfy accepts no liability for damage resulting from
failure to follow the instructions in this manual.
In case of any doubts when installing the drive, or to obtain
additional information, consult the website www.somfy.
com.
The instructions may be modified if and when there is a
change to the standards or to the drive.
1.3 Preliminary checks
> Installation environment
ATTENTION
Do not spray water onto the drive.
Do not install the drive in an explosive environment.
> Condition of the gate to be motorised
Only motorise a gate which has been correctly installed and
is in good working order.
Before installing the drive, check that:
- the gate is in good mechanical condition
- the gate is correctly balanced
- the gate is not equipped with any manual or electric
locking system (unless compatible with the Somfy drive)
- the structures supporting the gate allow the drive to be
securely fixed. Strengthen these if necessary.
- the gate can be opened and closed properly using a force
of less than 150 N.
1.4 electrical installation
The installation of the power supply must comply with
the standards in force in the country in which the drive is
installed, and must be carried out by qualified personnel.
The electric line must be exclusively reserved for the
drive and equipped with protection, comprising:
- a 10 A fuse or breaker,
- a differential type device (30 mA).
An
all-pole
power
must be provided.
It is recommended that you fit a lightning conductor
(maximum residual voltage 2 kV).
> Cable feed
Underground cables must be equipped with a protective
sheath with a sufficient diameter to contain the motor cable
and the accessories cables.
Low voltage cables subjected to inclement weather must be
at least RNF type.
For overground cables, use a cable grommet that will
withstand the weight of vehicles (ref. 2400484).
2
WARNING
DANGER
supply
cut-off
device
1.5 Safety instructions relating to installation
Do not connect the drive to a power supply (mains, battery
or solar) until installation is complete.
Ensure that any danger zones (crushing, cutting, trapping)
between the driven part and the surrounding fixed
elements caused by the opening movement of the driven
part are avoided or indicated on the installation (see "Risk
prevention").
Modifying one of the elements provided in this kit or using
an additional element not recommended in this manual is
strictly prohibited.
Monitor the gate as it moves and keep people away from it
until installation is complete.
Do not use adhesive to secure the drive.
Take care when using the manual unlocking device. Manual
unlocking may result in uncontrolled movement of the gate.
ATTENTION
Install any fixed control device at a height
of at least 1.5 m and within sight of the gate, but well
away from the moving parts.
A er installation, ensure that:
- the mechanism is correctly adjusted
- the manual back release device is operating correctly
- the drive changes direction when the gate encounters an
object 50 mm high positioned halfway up the leaf.
For the installation to be compliant, an active safety edge
must be installed.
> Safety devices
For operation in automatic mode or remote control,
photoelectric cells must be installed.
The automatic drive operates in at least one direction with
no intentional activation by the user.
For operation in automatic mode, or if the gate faces a public
road, an orange light type signalling device may be required
to comply with the regulations in the country in which the
drive is installed.
Copyright © 2015 - 2016 Somfy SAS. All rights reserved.
DANGER
WARNING
WARNING
WARNING
DANGER
WARNING
Publicité
Table des Matières
