Regulations; Assistance; Risk Prevention - SOMFY IXENGO L 230V RTS Manuel D'installation

Ixengo L 230V RTS
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection (special glasses, gloves, ear
protection, etc.).

1.6 Regulations

Somfy SAS declares that the product described in these
instructions, when used in accordance with the instructions,
complies with the essential requirements of the applicable
European Directives, and in particular Machinery Directive
2006/42/EC and Radio Equipment Directive 2014/53/EU.
The full text of the CE declaration of conformity is available
at: www.somfy.com/ce. Christian REY, Regulatory Manager,
Cluses

1.7 Assistance

You may encounter difficulties or have questions when
installing your drive.
Do not hesitate to contact us; our specialists are on hand to
answer all your questions. Internet: www.somfy.com

1.8 Risk prevention

Risk prevention - motorisation of a hinged gate for
residential use
> Risk zones: measures to be taken to eliminate risks.
RISK
ZONE 1
Risk of crushing during
closing
ZONE 2
Risk of trapping and
cutting on the surface of
the gate
Copyright © 2015 - 2016 Somfy SAS. All rights reserved.
WARNING
Zone 2 Zone 3
Zone 1
Zone 5
Zone 4
SOLUTION
Protection by safety edge(s)
the force; see paragraph Force
measurement)
For operation with automatic
closing, install photoelectric
cells (see installation manual)
Protection by safety edge(s)
the force; see paragraph Force
measurement)
Eliminate any gap ≥ 20 mm
ZONE 3
Risk of crushing with an
adjoining fixed part upon
opening
ZONE 4
Risk of trapping and
crushing between the
roller rails and bearings
ZONE 5
Risk of crushing
between the end of the
cylinder and the gate
No protection is required if the gate has continuous control
or if the danger zone is more than 2.5 m above ground or any
other permanent access level.
Figure 1 - Safety distance
Figure 2 - Mechanical protection
Deformable cover
ensuring a safety
distance of 25 mm
in the compressed
position
Protection by safety edge(s)
the force; see paragraph Force
measurement)
Protection via safety distances
(see figure 1)
Eliminate all sharp edges on the
guide rails
Eliminate any gap ≥ 8 mm
between the rails and the
bearings
Alter the installation dimensions
to ensure a space greater than
8 mm
Profile
3