Power Fist 8308231 Manuel Du Propriétaire page 5

8308231 Leather Punch with Eyelet Pliers V 2.0
ASSEMBLY
NOTE: When this manual refers to a part number, it refers to the included parts list.
The leather punch and eyelet pliers come pre-assembled.
OPERATION
THE LEATHER PUNCH
Turn the punch wheel (No.2) towards the front until you have found the correct punch setting. The narrowest
diameter is 2.5 mm and the size of each punch hole increases by .5 mm. The punch wheel clicks audibly every time
it reaches a new punch setting.
Test the diameter setting on scrap material to ensure it is the correct size.
Place the punch in the correct spot and squeeze the handles until the punch cuts through the material. The punch is
hollow and excess material will slide into the empty space. Once the punch is complete, this waste material can be
tapped out or removed with a long thin probe pushing it through punch opening and out of the inner side wheel.
Lock the leather punch in the closed position by squeezing the handles together and swinging the securing lever into
the security slot. To unlock the tool, squeeze the handles and swing the securing lever back out.
THE EYELET PLIERS
Punch a hole with the leather punch equal to the diameter of the rivet.
Insert the rivet into the hole with the wide side of the rivet on the exterior of the material.
5
For technical questions call: 1-800-665-8685