Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TEMPO Function
Use this to change the TEMPO while music is
playing.
1.
During playback (CD-DA/MP3/WMA), press
the TEMPO button on the remote control or
on the main unit.
2.
Select the desired TEMPO by using the
EFFECT-, + button on the remote control or
VOLUME/SEARCH JOG on the main unit.
| NOTES |
✎ You can set each of the TEMPO functions from
-10 to +10. The initial setting for all functions is 0.
✎ TEMPO Function does not operate in the
Bluetooth, TV SoundConnect, TUNER and
AUX mode.
✎ When you turn TEMPO off, all TEMPO settings
are lost.
BOOTING SOUND Function
When the Booting Sound Function is on, your Hi-Fi
component demonstrates it's audio prowess as
it boots up.
1.
Press the product's GIGA PARTY button or
the remote control's GIGA button for about
3 seconds. The BOOTING SOUND menu
appears on the display panel.
2.
Press the product's GIGA PARTY button or
the remote control's GIGA button for about 3
seconds to turn the BOOTING SOUND.
Software Update
Samsung may offer updates for the product's
system firmware in the future.
If an update is offered, you can update the
firmware by connecting a USB device with the
firmware update stored on it to the USB port on
your product.
Note that if there are multiple update files, you
must load them onto the USB device singly and
use them to update the firmware one file at a time.
Please visit samsung.com or contact the
Samsung Call Center to receive more information
about downloading updates files.
• Select USB function, insert a USB device
containing the firmware update into the USB
port on the main unit.
• Updating firmware may not work properly if
audio files supported by the product are stored
in the USB storage device.
• Do not disconnect the power or remove the
USB device while updates are being applied.
The main unit will turn off automatically after
completing the firmware update.
• After the update, all settings are reset to their
factory default settings. We recommend you
write down your settings so that you can easily
reset them after the update.
If the firmware fails to update, we recommend
formatting the USB device in FAT16/FAT32 and
trying again.
• Once the software update is completed, turn
on the product with no disc inserted. The "NO
DISC" message appears on the display. Press
and hold the STOP button on the main unit for
longer than 5 seconds. "INITIAL" appears on
the display and the unit powers off. The upgrade
is complete.
• Do not format the USB device in the NTFS
format. The product does not support the NTFS
file system.
• Depending on the manufacturer, some USB
devices may not be supported.
• If the firmware fails to update, most functions
will become inoperable and "PLEASE UPDATE
MPEG SW" will appear on the display. Update
the firmware again.
27
English
Publicité
Table des Matières
Dépannage
