Base Molding - Skil 3800-02 Consignes De Fonctionnement/Sécurité

• Base molding can be cut vertical against fence or flat on
the table.
SETTINGS
/
INSTRUCTIONS
Sliding Fence
Bevel Angle
Molding position
Inside
Miter Angle
corner of wall
Outside Miter Angle
corner of wall
Saw Operations

Base Molding

BASE MOLDING CUTTING INSTRUCTIONS
Vertical Position
Back of molding is
against the fence
Far Right Position
Left Side
Left at 45°
Molding Bottom
position against table
Finished Keep left
side side of cut
Right at 45°
Molding Bottom
position against table
Finished Keep left
side side of cut
• Follow the table for helpful hints on cutting base molding.
0°
Right Side
Right at 45°
Bottom Top against
against table
Keep right
side of cut
Left at 45°
Bottom Bottom against
against table
Keep right
side of cut
58
Horizontal Position
Back of molding is flat
on the table
Move to proper position
45°
Left Side Right Side
0° 0°
Bottom
fence against fence
Keep left Keep left
side of cut side of cut
0° 0°
Top against
fence fence
Keep right Keep right
side of cut side of cut