Table des Matières
Publicité
SM 2610008289 10-13_3310 Table Saw 10/14/13 9:46 AM Page 24
Getting To Know Your
Table Saw
1. POWER SWITCH
Has a design feature allowing the tool to be locked in the OFF
("O") position.
2. TABLE
Provides large working surface to support workpiece.
3. BASE
Supports table saw. For additional stability, holes are provided
in base to bolt the saw to a workbench or stand.
4. BLADE ANGLE LOCK
Locks the tilt mechanism after the blade is adjusted to desired
position.
5. ELEVATION WHEEL
Elevates or lowers the blade. Also used to adjust blade bevel
at all angles from 0 to 45 degrees.
6. BLADE TILT SCALE
Shows the degree the blade is tilted.
7. RIP FENCE SCALE
Shows the distance from the blade to rip fence.
8. MITER GAUGE SCALE
Shows the degree the workpiece is being mitered.
9. RIP FENCE STORAGE
Conveniently stores rip fence on two pads on the right side of
base when not in use. Simply align hole on fence with locating
pin on front pad, and press fence down into it's storage
position as shown.
10. MITER GAUGE STORAGE
Conveniently stores miter gauge on the left side of the base
when not in use. Simply insert miter gauge bar into
rectangular hole on right side of base, and push the miter
gauge fully into it's storage position as shown.
11. PUSH STICK
Allows you to rip smaller pieces of stock with a greater level
of safety.
12. SMART GUARD SYSTEM STORAGE
When not in use, the Main Barrier Guard (a) and Anti-
Kickback Device (b) can be stored under the left side table
extension.
13. BLADE STORAGE & WRENCH
Allows you to store 10" blades and arbor wrench.
14. RIP FENCE
Exclusive Self-Aligning, Quick-Set rip fence can be easily
moved or locked in place by simply raising or lowering lock
handle.
2
8
6
5
1
11
FIG. 2
9
12a
FIG. 3
10
24.
7
FIG. 1
4
3
13
14
12b
Publicité
Chapitres
Table des Matières
