Table des Matières
Publicité
"READ ALL INSTRUCTIONS" — Failure to follow the SAFETY RULES identified by BULLET (l) symbol listed
!
WARNING
BELOW and other safety precautions, may result in serious personal injury.
•
Cut only one workpiece at a time. Multiple workpieces
cannot be adequately clamped or braced and may bind
on the blade or shift during cutting.
Be certain the miter saw is mounted or placed on a
•
level, firm work surface before using. A level and firm
work surface reduces the risk of the miter saw becoming
unstable.
•
Plan your work.
accessories such as tables, saw horses, table
extension, etc. for workpieces wider or longer than
the table top (see page 46). Workpieces longer or wider
than the miter saw table can tip if not securely supported.
If the cutoff piece or workpiece tips it can lift the lower
guard or be thrown by the spinning blade.
Do not use another person as a substitute for a table
•
extension or as additional support. Unstable support
for the workpiece can cause the blade to bind or the
workpiece to shift during the cutting operation pulling you
and the helper into the spinning blade.
The cutoff piece must not be jammed against or
•
pressured by any other means against the spinning
saw blade. If confined, i.e. using length stops, it could
get wedged against the blade and thrown violently.
Always use a clamp or a fixture designed to properly
•
support round material such as dowel rods, or
tubing. Rods have a tendency to roll while being cut,
causing the blade to "bite" and pull the work with your
hand into the blade.
When cutting irregularly shaped workpieces, plan
•
your work so it will not slip and pinch the blade and
be torn from your hand. A piece of molding, for
example, must lie flat or be held by a fixture or jig that will
not let it twist, rock or slip while being cut.
Let the blade reach full speed before contacting the
•
workpiece. This will help avoid thrown workpieces.
If the workpiece or blade becomes jammed or
•
bogged down, turn miter saw "OFF" by releasing
Provide adequate support
"SAVE THESE INSTRUCTIONS"
Safety
switch. Wait for all moving parts to stop and unplug
the miter saw, then work to free the jammed material.
Continued sawing with jammed workpiece could cause
loss of control or damage to compound miter saw.
Braking action of the saw causes the saw head to
•
jerk downward. Be ready for this reaction when
making an incomplete cut or when releasing the switch
before the head is completely in the down position.
After finishing the cut, release the switch, hold the
•
saw arm down and wait for blade to stop before
removing work or cutoff piece. If blade does not stop
within five (5) seconds, unplug the saw and follow
the instructions in the Troubleshooting section.
REACHING WITH YOUR HAND UNDER A COASTING
BLADE IS DANGEROUS!
!
WARNING
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other
masonry products, and
• Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending on how
often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work
with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles.
•
There are additional safety instructions for particular
operations of the saw in the operating section. Read
the rest of the manual for safe operation.
4
Some dust created by power sanding,
sawing, grinding, drilling, and other
Publicité
Table des Matières
