Table des Matières
Publicité
Basic Saw Operations
Sliding Base/Fence Extension
Extend and use sliding base/fence when
!
WARNING
making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6") spacing
from hand to saw blade.
Sliding Base:
Loosen the thumbscrew 1 in sliding base channel
1.
(Figure 23).
Slide sliding base/fence 2 to the desired position.
2.
3.
Tighten thumbscrew 2.
Sliding Fence:
Unlock the fence locking lever 3 (Figure 24).
1.
2.
Slide fence to proper position 4.
3.
Relock fence in place.
4.
Move the head assembly to check clearance with fence.
During transportation, sliding base and
!
CAUTION
fence should always be secured in the full
in position.
Stop Block:
Stop block can be used to make repetitive length cuts.
1.
Attach stop block 5 to extension rail 6 (Figure 25).
2.
Loosen thumbscrew 7 on backside of stop block 5.
3.
Slide stop block to desired length of cut.
4.
Tighten thumbscrew.
Note: Stop block can be stored by loosening knob and
flipping stop block.
FIG. 23
FIG. 24
FIG. 25
5
50
2
1
4
3
7
6
Publicité
Table des Matières
