Lindy 39312 Manuel Utilisateur page 6

User Manual
Before starting the installation, please ensure that all devices are powered off.
1. Connect a DisplayPort monitor to the Console Video port with a DP cable (maximum length 3m)
2. Connect USB Keyboard and Mice in the USB HID ports on the rear panel of the unit.
3. Connect speaker or headphones to the jack 3.5mm port on the rear panel of the unit.
4. Connect two DisplayPort sources to the PC ports with two DP cables (maximum length 3m).
5. Connect two USB 3.0 (3.2 Gen1x1) PC ports to USB ports of PCs with two USB 3.0 (3.2 Gen1x1) A
to B cables (maximum length 3m).
6. Use 3.5mm audio cables to connect audio PC ports to audio sources.
7. Once all connections are made please connect the power supply and power on all devices.
Operation
Computer port selection can be made using the push buttons on the front panel or via hotkey
commands.
Front Panel Buttons
Press the front push button to select the appropriate port/computer, the switching will be confirmed by a
beep. Depending on the configuration, only the KVM ports (USB keyboard, mouse and monitor) or KVM
and USB 3.0 (3.2 Gen1x1) and/or Audio ports are switched. To learn more about these features, please
refer to the keyboard hotkey switching options below.
Keyboard Hotkeys
Hotkey commands can be activated pressing leading codes "Scroll Lock" + "Scroll Lock" or "Left
Ctrl" + "Left Ctrl"*.
Hotkey
Leading code + "1" or "2"
Leading code + "F1"
Leading code + "F2"
Leading code + "F3"
Leading code + "F5"
Leading code + "A"
Leading code + "F7"
Leading code + "U"
*Please Note: To change Hotkey leading code "Left Ctrl" to "Right Ctrl", please press "Left Ctrl" + "Left
Ctrl" + "Alt" (press & hold) + "Right Ctrl", then you can release "Alt".
Function
Computer port selection 1 or 2
Start Auto Scan
Start Manual Scan: press
Adjust Scan Rate: the switch generates 1 to 4 beeps indicating duration of
scan period (3, 8, 15 and 30 seconds respectively)
Bind/Unbind Audio with KVM switching
Force Audio to follow the active KVM port
Bind/Unbind USB 3.0 (3.2 Gen1x1) port with KVM switching
Force USB 3.0 (3.2 Gen1x1) port to follow the active KVM port
or key to select previous or next port
▲ ▼
English