Dreame V12 Pro Mode D'emploi page 11

Installation
EN
2-in-1 Charging & Storage Mount Installation Diagram
The 2-in-1 charging & storage mount is an optional accessory. You can install it based on
your needs.
Note: The 2-in-1 charging & storage mount should be installed in a cool, dry place with
an electrical outlet nearby. Prior to installing, ensure that there are no electrical wires or
pipes in the space directly behind where the mount will be installed.
1. Paste the mounting template sticker on the wall and keep it parallel to the ground. It is
recommended that the bottom of the sticker is at least 119 cm off the ground.
2. Use a power drill with an 8mm drill bit to drill a hole into each marker on the mounting
template sticker, then insert a wall plug into each hole.
3. Align the locating holes on the mount with the holes on the wall. Fasten it to the wall
with the included screws.
Recommended mounting height: The bottom of the mounting template sticker should be
at least 119 cm from the ground.
8
119 cm