Hendi 215012 Mode D'emploi page 7

RESET the Hi-limiter (Thermal cut-out)
Attention: Please note that there is a RESET button located at the rear side of the appliance to prevent the
appliance from overheated.
• Unplug the appliance from the electrical power
outlet and allow the appliance to completely cool
down.
• Unscrew the black protective cap of the RESET
button.
Error codes display
Error codes shown on the display (6)
E01
E02
E03
E04
E05
E06
E07
E08
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning & storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the surface with a slightly damp cloth or
sponge with some mild soap solution.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
• Press the RESET button of the Hi-limiter (Ther-
mal cut-out). You should hear a click sound.
• Screw back the protective cap on the RESET but-
ton.
Possible cause
The internal temperature of the
appliance is too high. Buzzer alarm
sound is heard.
The appliance is overheated and
buzzer alarm sound is heard.
Input supply voltage is too high
(>265v).
Input supply voltage is too low
(<135v).
Oil temperature sensor short /
open circuit.
Coil temperature sensor short cir-
cuit.
Coil temperature sensor open cir-
cuit.
Coil temperature sensor over heat.
• Never use abrasive sponges or detergents, steel
wool or metal utensils to clean the interior or ex-
terior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
Possible solution
Press ON / OFF (1) button to switch OFF
the appliance and unplug the appliance,
wait until the appliance is completely
cool down. Also RESET the Hi-limiter.
Press ON / OFF (1) button to switch OFF
the appliance and unplug the appliance,
wait until the appliance is completely
cool down. Also RESET the Hi-limiter.
Make sure that the appliance is connect-
ed to a suitable electrical power supply.
Make sure that the appliance is connect-
ed to a suitable electrical power supply.
Please contact your supplier.
Please contact your supplier.
Please contact your supplier.
Please contact your supplier.
EN
7