Fein GRIT GI 150 Mode D'emploi page 12

GI75.book Seite 12 Mittwoch, 19. Juli 2006 7:49 07
EN
The workpiece must always lie securely on the
grinding rest and the stop. Workpieces that are
too small or too thin may not be worked. Danger
of injury from workpieces being thrown from
the machine.
Never touch the running grinding belt. Dan-
ger of injury.
Press the emergency-off switch immediately in
danger situations. The machine runs on for up to
50 seconds.
Clean the ventilation slots of the machine regu-
larly. The motor fan draws dust into the housing.
Excessive accumulation of metal dust can cause
electrical dangers.
Ensure that the machine is positioned securely
and horizontal. Serious injuries can be caused if
the machine tips over during operation.
The mains plug of the machine may be mounted
only by a qualified electrician. The protective
conductor in the mains socket outlet must be
connected with the protective earthing of the
mains supply.
Pull out the mains plug for maintenance and
repair! Switching the machine on unintentionally
can lead to serious injuries.
Have the electrical safety of the machine checked
regularly in accordance with statutory regula-
tions. For machines that have not been checked,
there may be danger of electrical shock!
Check the rotation direction of the motor before
starting the operation of the machine for the first
time. If the rotation direction of the motor is
incorrect, the workpiece can be thrown from
the machine and cause an accident. The rotation
direction may be changed only by a qualified
electrician.
Make sure that you or other persons are not
standing directly next to the grinding belt when
switching the machine on. The grinding belt can
tear apart and cause serious injuries.
12
At a glance.
1 Protective cover, top
2 Star-knob bolt for protective cover
3 Screws for gap adjustment
4 Stop
5 Spark guard
6 Spark guard wing bolts
7 Grinding rest
8 Dust collector
9 Connection sleeve for dust extraction
10 Star-knob bolt for dust box
11 Star-knob bolt for grinding rest
12 Adjustment screw for face- grinding rest
13 Belt tension lever
14 Screws for coarse adjustment of belt tension
15 Emergency OFF pushbutton
16 Plug
17 Star-knob bolt for adjusting the tracking of the
grinding belt
18 Ventilation slots
19 On/Off switch
20 Speed switch (only for 2H models)
21 Contact wheel
22 Face- grinding rest
23 Drive wheel
24 Lubricating nipple
25 Screw for side cover
26 Side cover
27 Instruction label
Intended use of the machine.
The machine is intended for stationary sanding/
grinding of metal materials using manufacturer
approved grinding belts, or for mobile use with
the GRIT GIM undercarriage.
GI 75 / GI 150