Vermeiren Eco-Plus Manuel D'utilisation page 9

Height adjustments
To adjust the height of the rollator:
1. First adjust the seat height.
2. Next adjust the height of both
handgrips.
Height of seat
CAUTION
Make sure that both brake levers are in
parking position before sitting down,
see §5.1.
1. Turn the base frame and place it with
all four wheels on the ground.
2. Turn seat and backrest down.
3. Check whether the seat is horizontal. If
not, adjust the assembled wheels (see
§4.1 and 4.2) at the same height.
4. Sit down on the seat according to §5.3.
5. Check whether the seat is at the
correct sitting height. If not, adjust the
assembled wheels (see §4.1 and §4.2)
and make sure that they are at the
same height.
Height of handgrips
1. Loosen knob (12) (see §4.2) and
remove from frame.
2. Adjust the handgrip to the desired
height. When standing straight, the
handgrip should be as high as your
wrist. Leave your arms hanging loose.
3. Place knob (12) in the holes of the
tube and tighten firmly by hand.
4. Adjust the other handgrip in the same
manner. Make sure that both
handgrips have the same height.
Mounting of storage bag
CAUTION
Do not overload the storage bag.
The maximum carrying weight of the
storage bag can be found in the table of §8.
The storage bag is meant to be mounted
below the seat, on the two horizontal tubes
where the seat rests on.
1. Pull seat fame (23) a bit up to make
room.
2. Mount the storage bag with the six snap
fasteners (20) and two Velcro straps
Risk of falling
Risk of falling,
tipping over
EN - 5
(21). Make sure that the two protection
sleeves (22) stay uncovered.
3. Push seat and seat frame down.
Figure 8: Storage bag assembly
21
22
Disassembly
CAUTION
Pay attention to the position of the brake
cables and don't pull the handgrips too
high to prevent damage to the brake
cable.
The disassembly of the rollator is
conducted in reverse order to the
assembly described in previous section:
1. Storage bag: Open snap fasteners and
Velcro straps to remove the bag.
2. Velcro strap for walking stick: Remove.
3. Cable clamp (2x): Pull it from the frame
tube carefully.
4. Handgrip with brake lever (2x): Remove
knob (12) and pull the handgrip out of
the base frame.
5. Base frame: Turn and place it with the
front frame on a surface.
6. Wheel support with rear wheel (2x):
Press and hold silvery push button (16)
and pull the wheel support out of the
base frame.
7. Base frame: Turn and place it with the
rear frame on the surface.
8. Front-wheel frame (8): Remove on
each side, fastener pin (7) and pull the
tubes out of the base frame.
Eco-plus
2018-02
23
20
Risk of damage
to the brakes
EN
NL