Assembly And Disassembly - Vermeiren Eco-Plus Manuel D'utilisation

ambient temperature, solar radiation,
heating devices, etc. Be careful when
touching.
•
Before every usage, check that the
height adjustments are firmly secured,
see §4.1 and 4.2.
•
Do not hold the handgrips with wet
hands. If you do so, you can lose your
grip and lose your balance.
•
Do not proceed with your rollator into
traffic. Always stay on the pavement.
•
Take note of the instructions for care
and service. The manufacturer is not
liable for damage caused by improper
servicing / care.
Symbols on the rollator
Identification plate is located beneath
the left handgrip at the inner side of
the base frame
Maximum weight of user
Type designation
Shipping and storage
The shipping and storage of the rollator
shall be according following instructions:
•
Store in a dry place
•
with a temperature between +5°C
and +41°C
•
with a relative humidity of the air
between 30% and 70%.
•
Provide sufficient covering or
packaging to protect the rollator from
rust and foreign bodies (e.g. salt water,
sea air, sand, dust).
•
Make sure no objects are stored on or
against the rollator to prevent damage.
4

Assembly and disassembly

CAUTION
Assemble the rollator completely,
before adjusting its height.
Assembly of front-wheel frame
1. Unfold base frame (18).
2. Place the base frame on ground or
table, with the oval tubes flat on the
surface.
3. Take front-wheel frame (8) and insert
both tube ends in the protruding, round
tubes of the base frame. Make sure
that the wheel support (w) is on the
inside of the base frame.
Figure 2: Front wheel frame, inserted
18
w
4. Adjust the tube length of the front-
wheel frame (8) by sliding the tubes
in/out.
5. Check on each side, whether the holes
of inner and outer tubes match.
Figure 3: Fastener pin, inserted
6. Insert fastener pin (7)
in the hole of the
height adjustment.
Make sure that the pin
is completely inserted;
a click is heard when
fastener clip clasps
the tube.
7. Repeat this at the other frame tube.
8. Check the tube length at left and right
side. If the length differs, remove the
fastener pin at one side and adjust the
length according to step 4, 5 and step
6.
EN - 3
Eco-plus
2018-02
Risk of injuries
8
7
EN
NL