Sharp ER-A160 Manuel D'instructions page 37

Automatic Modification of Register System for Introduction of EURO
To make your register correspond to the introduction of EURO, your register system can be automatically
modified. According to the steps of the introduction, you can make your register correspond to EURO.
Set the manager key (MA) to X2/Z2 position, and use the following sequence.
800
*A=1: Applicable for period 1
*A=2: Applicable for period 2
*A=3: Applicable for period 3
• A cashier must be signed-on before this operation.
• You can perform each operation only once with the substitution of "A=1", "A=2" and "A=3". If you
The details of the automatic register system modification are as follows:
(As for PGM functions described below, please refer to "Programming EURO system settings" and
"Programming function parameters for
When "1" is substituted to "A":
1.
Issuing a general Z1 report
2.
Issuing a general Z2 report
3.
Setting "printing" for a PGM function "Printing exchange total amount and change amount on receipt or
journal"
4.
Setting "division" for a PGM function "Exchange calculation method"
5.
Setting the EURO symbol ( ) for the currency symbol of exchange key, and setting "2" for the number of
digits after decimal point of exchange amount
6.
Setting the round-off function for currency exchange
After the execution of the procedure with the substitution of "1", treat EURO as foreign currency using the
exchange key (
When "2" is substituted to "A":
1.
Issuing a general Z1 report
2.
Issuing a general Z2 report
3.
Resetting GT
4.
Setting "printing" for a PGM function "Printing exchange total amount and change amount on receipt or
journal"
5.
Setting "multiplication" for a PGM function "Exchange calculation method"
6.
Changing the domestic currency symbol to the EURO symbol ( ) and setting the number of digits after
decimal point of the domestic currency amount to 2
7.
For the setting of the currency symbol and the number of digits after decimal point of exchange amount, the
ones that had been set to the domestic currency are set.
8.
Setting the round-off function for currency exchange
After the execution of the procedure with the substitution of "2", treat EURO as domestic currency, and previous
national currency as foreign currency using the exchange key (
Since EURO becomes domestic currency in your register after execution of the procedure with the substitution
of "2", you must change unit prices in each department and PLU to make prices correspond to EURO before
actually you start operating your register again. As for the miscellaneous keys, also please change the rates or
amounts so that they are based on amounts in EURO.
Downloaded from: http://www.usersmanualguide.com/
. ≈
perform the operation with the substitution of "A=2" first, you cannot perform the operation with
the substitution of "A=1". If you perform the operation with the substitution of "A=3" first, you
cannot perform the operation with the substitution of "A=1" and "A=2".
e
e
) with the preset rate entry.
É
*A
key".)
e
) with the preset rate entry.
REG
OPX/Z MGR
X1/Z1
X2/Z2
PGM
35