Reading (X) And Resetting (Z) Of Sales Totals; Summery Of Reading (X) And Resetting (Z) Reports - Sharp ER-A160 Manuel D'instructions

READING (X) AND RESETTING (Z)
OF SALES TOTALS
• Use the reading function (X) when you need to take a reading of sales information entered since the last
resetting. You can take this reading any number of times. It does not affect the register's memory.
• Use the resetting function (Z) when you need to clear the register's memory. Resetting prints all sales
information and clears the entire memory except for the GT, reset count, and consecutive number.
Summary of reading (X) and resetting (Z) reports
1
X1 and Z1 reports: Daily sales reports
X2 and Z2 reports: Periodic (monthly) consolidation reports
Item
Flash report:
(Only display)
To clear the display,
c
press the
turn the mode switch to
another position.
General report
Individual cashier
report
Full cashier report
PLU sales report
Hourly sales report
• In the reports, when both of sales quantity and sales amount are zero, their printing is skipped. If
you do not want to skip, change the programming. (Refer to "Programming print format".)
• "X" represents read symbol and "Z" represents reset symbol in the reports.
Downloaded from: http://www.usersmanualguide.com/
Mode switch position
OPX/Z X1/Z1
X --
key or
-- X1, Z1
X, Z --
-- X1, Z1
-- X1, Z1
-- X1, Z1
REG
OPX/Z
MGR
X1/Z1
X2/Z2
PGM
X2/Z2
Dept. key or
Ó
Dept. key (ER-A180 only)
--
≈
key: Amount of cash in drawer
É
key: Sales total
Reading
.
X2, Z2
Resetting
Reading
.
--
Resetting
(The report of the cashier currently signed-on)
Reading
.
--
Resetting
All PLUs
--
Start
PLU code
Reading
.
--
Resetting
REG
OPX/Z MGR
X1/Z1
X2/Z2
PGM
Key operation
:Department total amount
É
‹
‹
Reading
End
≈
PLU code
Resetting
Ñ
REG
OPX/Z MGR
X1/Z1
X2/Z2
PGM
. Ö
21