Function Button; Inserting The Batteries; Functions And Operation - Sportplus SP-HT-1003 Instructions D'utilisation

FUNCTION BUTTON

FUNCTION BUTTON:
• Use this button to select the functions time, speed, distance, calories and pulse.
Press and hold the button for

INSERTING THE BATTERIES

1. Remove the battery compartment cover on the back of the monitor.
2 Heeding correct polarity, insert
cover.
3 If the display can no longer be read or if only some segments are visible, please
remove the batteries and wait
batteries properly in accordance with local regulations.
4 The monitor display goes out when the batteries are removed.

FUNCTIONS AND OPERATION

AUTO ON / OFF:
• The monitor turns on automatically when the home trainer is used. The monitor turns
off automatically when the pedals are not used for 4 minutes.
SCAN:
• Press the MODE button until a triangle next to „Scan" in the upper left-hand corner of
the display appears. The LC display now shows all functions and values in succession.
Each function is shown for approx. 4 seconds.
TIME:
• Automatically measures the time as soon as training begins.
SPEED:
• Shows the current training speed.
DISTANCE:
• Shows the distance covered during training.
CALORIES:
• Shows the calories consumed during training. This is an approximate value.
PULSE:
• Automatically registers and shows the corresponding heart rate during training.
Press the button until the arrow points to PULSE. The monitor now shows the current
heart rate per minute. To measure your pulse, place the palms of your hands on both
contact surfaces. The LC display then shows your current heart rate per minute.
Note: The heart rate monitor is intended as a training aid and not as a medical device.
If you feel unwell, please cease training immediately and contact your physician.
SP-HT-1003-IM-V03-INT.indb 35
2 seconds to reset.
2 AAA batteries into the compartment and replace the
15 seconds before reinserting them. Dispose of empty
35
19/6/15 4:53 pm