Frequency Measurements; Temperature Measurements - PeakTech 1610 Mode D'emploi

5. Touch the probes to the capacitor. Always observe polarity
makings when measuring pobrized capacitors.
6. Read capacitance value directly from the display.
7. After completing the measurement, disconnect the DCM test
leads.

6.7. Frequency measurements

1. (P 1610)
(P 1615)
(P 1625)
2. Plug the black and red test leads into the COM and Hz input
terminals respectively.
3. Determine that the amplitude level of the signal to be
measured is not greater than the input voltage limit (250 V
AC/DC). The signal amplitude must also be greater than the
sensitivity level.
4. Attach the probe tips to the points across which the
frequency is to be measured, and read the result directly
from the display.
5. Disconnect the DCM test leads.

6.8. Temperature measurements

1. Set the function switch to °C °F or TEMP position. The meter
automatically defaults to °C range.
2. Insert the meter´s white temperature adaptor into the V/-
input terminal and the COM-terminal. Ensure that the minus
marking at the adaptor is inserted into the COM-terminal and
the plus-marking is inserted into the V/-input terminal.
Set the rotary selector switch to the Hz
position.
Set the function switch to V/Hz%-position
and select Hz or %duty with the Hz%-button.
Set the function switch to V/Hz-position and
press the MODE-button for >2 seconds to
select the frequency range.
-46-