Safety Information - PeakTech 1610 Mode D'emploi

Opening the equipment and service – and repair work must
*
only be performed by qualified service personnel
Measuring instruments don't belong to children hands.
*
CAUTION!
Note on using the supplied safety test leads according the
IEC / EN 61010-031:2008:
Measurements in the field of overvoltage category CAT I or CAT
II can be performed with test leads without sleeves with a
maximum of up to 18mm long, touchable metallic probe,
whereas for measurements in the field of overvoltage category
CAT III or CAT IV test leads with put on sleeves, printed with
CAT III and CAT IV must be used, and therefore the touchable
and conductive part of the probes have only max. 4mm of
length.

1.1. Safety information

Caution! Refer to accompanying documents.
This meter was "tested safety", according to the
Equipment and Product Safety Act (GPSG)
Caution! Risk of electric shock.
Equipment
insulation (class II)
Alternating current
Direct current
Ground
However, electrical noise or intense electromagnetic fields in the
vicinity of the equipment, may disturb the measurement circuit.
Measuring instruments will also respond to unwanted signals
that may be present within the measurement circuit. Users
protected throughout
-28-
by double