Olimpia splendid DOLCECLIMA Aria 8 Mode D'emploi Et D'entretien page 56

3.4 - USE OF THE APPLIANCE
Work as follows in order to use the appliance.
To prevent possible damages to the compressor, each start is delayed by 3 minutes
with respect to the last switching off.
3.4.a - Preliminary operations
• Place the appliance on a stable and not inclined base, at at least 20/30 cm. from
the wall or from any other object, in order to ensure the correct air circulation.
(Fig.1). Place it on a water-resistant surface since the possible water leakage
could damage furniture or the floor.
• Do not place the appliance directly on carpets, towels, blankets or other absor-
bent surfaces.
• Insert the plug in the power socket. The appliance emits a "beep", on the display
appears the icon
Before electrically connecting the appliance, make sure the plate data correspond
to those of the electricity distribution network.
3.4.b Appliance switching on/off
a. To start the appliance, press the key "ON/OFF" on the remote control or the key
b. A beep warns that the appliance is in operation and the flap (23) raises.
c. The icon switches on on the control panel.
d. appears on its display
e. In case of prolonged stop of the appliance, it must be reset by removing the plug from the power socket,
wait 5÷10 seconds and then reinsert it; a beep signals that the appliance is ready for use.
3.5 AUTO MODE (Automatic)
a. When this mode is selected, the appliance automatically activates the COOLING, HEATING (only for
version with heat pump) or FAN functions depending on the environment temperature and on the set one.
The environment temperature is continuously checked to obtain an optimal comfort in the air conditioned
room.
b. This mode can be selected by pressing the key "MODE" once or more (on the remote control or on the
control panel) until when the specific icon ECO and Blue Air is shown on the display of the control panel
and/or when the icon Auto appears on the remote control display.
c. It is not possible to select the fan speed in AUTO mode.
3.6 COOLING MODE (COOL)
a. When this mode is selected, the appliance dehumidifies and cools the environment.
This mode can be selected by pressing the key "MODE" once or more (on the remote control or on the
control panel) until when the specific icon
b. In this mode, the fan is always switched on and it is possible to select its desired speed by pressing the
key "FAN" on the remote control or the key
The fan speed is displayed as indicated in paragraphs "3.1" (point SW7) and "3.2" (point B3).
c. The temperature set-point is included between 17°C and 30°C (from 62 F and 86 F) with 1°C variations
and it can be set using the keys +/- on the control panel or with the keys ▲ ▼ on the remote control.
EN - 18
and the environment temperature in °C.
appears on its display.
appears on the display.
on the control panel.
on the control panel.