Pleasant Hearth OFG418TA Mode D'emploi page 14

ASSEMBLY INSTRUCTIONS
6. Hang the chain (H) from the posts (F) as illustrated
in figure 6 so that it connects from corner to corner.
When the fire table is fully assembled, the tank will
be placed in the tank hole on the bottom plate (I).
Make sure that the chain is positioned so that it will
not block the tank.
7. Attach the door bracket (L) to the two front posts (F)
with two M6X12 bolts (AA). Do not tighten the bolts yet.
Hardware Used
AA
Bolt M6 X 12
II
Phillips screwdriver
8. Door (M,O) installation
8-1. Insert the bottom peg of door (left) (O) to the
corresponding hole of the bottom plate (I) as
illustrated in figure 8-1. Slightly lift the door bracket
(L) and insert the top peg of the door (left) (O) to the
corresponding hole of the door bracket (L).
8-2 Repeat above procedure to complete the
assembly of door (right) (M).
Adjust the distance between the doors (M, O) and
the door bracket (L). Adjust the distance between
the doors (M, O) and the bottom plate (I). These
adjustments ensure both doors can open easily.
Tighten the door bracket (L) with screwdriver (II).
Hardware Used
II
Phillips screwdriver
6
4
7
6
X 2
8-1
O
BOTTOM PEG
8-2
O
F
14
Q
H
E
DD
AA
L
TOP PEG
L
L
L
F
I
F
I
I
M