Pleasant Hearth OFG418TA Mode D'emploi page 16

ASSEMBLY INSTRUCTIONS
11. Burner Assembly Installation
11-1. Make sure the control knob faces the front side
of the unit where the doors are located. Line up
holes in the burner assembly (C) with screw
holes on the table. Insert four M5X12 screws
(DD) through the holes. Fasten with
screwdriver (II).
Hardware Used
DD
Screw M5 X 12
II
Phillips screwdriver
11-2. The assembled unit will look like figure 11-2.
12. Pour one pack of the glass rocks (K) over the
burner. Do not cover ignition screen with glass
rocks (K). Use a glove when handling glass rocks.
WARNING
DO NOT COVER THE IGNITION SCREEN when
placing the glass rocks into the fire bowl. Always
keep Ignition Screen visible. This screen must be
clear and free of obstructions at all times to insure
proper operation.
Screen
Do not place glass
rocks on screen.
Keep screen clear.
The burner of the firebowl must be covered by glass rocks
completely. Otherwise the flame may be extinguished occasionally.
See the Figure CORRECT and INCORRECT for reference.
CAUTION
GLASS ROCKS - Use a glove when handling glass rocks.
1. Do not light or use gas unit if glass rocks are wet. Make sure glass rocks are completely dry before lighting as intense heat could
cause the rock to crack.
2. Glass rocks could hit a person's face or eyes during the initial startup of this unit. Keep away from the appliance for the first 20
minutes after lighting.
3. Use only Pleasant Hearth / GHP Group, Inc. factory-authorized glass rocks. The use of any glass rock that is not factory-
authorized can be dangerous and will void your warranty.
4. Do not add additional rocks to the fire bowl. Only 14.33 lbs/6.5 kgs are approved for safe use with this fire pit.
5. Do not use two different sizes of glass rocks at the same time.
6. Do not mix glass rocks with lava rocks.
11-1
X 4
11-2
12
CORRECT
INCORRECT
16
C
P
P
DD
A
K