Pleasant Hearth OFG418TA Mode D'emploi page 17

ASSEMBLY INSTRUCTIONS
13. Screw the knob (A) on the table lid (B) with one
M4X6 screw (EE) or one M4X10 screw (FF) and
one washer ø4 (GG). Tighten with phillips
screwdriver (II).
Hardware Used
EE
Screw M4 X 6
FF
Screw M4 X 10
GG Washer ø4
II
Phillips screwdriver
14. Place the table lid (B) over the fire pit.
Total fire pit installation is complete.
Caution: Never place a table lid on the
fire pit when in use. Ensure the fire pit
has cooled before placing a table lid over
the fire pit.
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE. INTENDED FOR
RESIDENTIAL USE ONLY.
Use a glove when handling glass rocks.
Do not sit or stand on this table.
Keep children away during assembly. This item contains small parts which can
be swallowed by children.
Do not use indoors and inside any enclosure.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
15. Use only 20-pound cylinders (approximately
18 ¼ inches high and 12 ¼ inches in diameter)
equipped with a cylinder connection device
compatible with the connection for the hose
regulator supplied with this appliance. Propane
gas and cylinder are sold separately.
A dented, rusted or damaged propane cylinder
may be hazardous and should be checked by your
cylinder supplier. Never use a propane cylinder
with a damaged valve connection.
X 1
(OFG418TA, OFG900T, OFG901T)
X 1
(OFG444T)
X 1
17
10-2
13
A
14
15
Standard 20 lb. tank
B
GG
EE