Hypertherm Powermax 1000 Mode D'emploi page 4

5. Tilt the power supply on its side.
6. Remove the screws (2) that secure the manifold to the
bottom of the power supply.
Remove the manifold.
Install new manifold
1. Attach the torch lead to the new manifold (through the front
panel).
2. Align the manifold with the holes on the bottom of the
power supply and secure it with screws.
3. Tilt the power supply upright.
4. Replace the ETR barrier.
5. Install the gas hose into the fitting.
Push the hose into the fitting until it stops.
Pull back firmly on the hose to make sure it is fully seated.
6. Plug the solenoid wire connector into the power board
receptacle (J20).
7. Slide the cover over the power supply.
Secure it with screws (12).
Field Service Bulletin
6
1
Torch lead
4
5
ETR barrier
Screw
GAS MANIFOLD REPLACEMENT
Screws
2
Screws
Gas hose fitting.
6
Solenoid wire connector (J20).
3
2