Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.
Never force the tool. Excessive pressure could bend or break the drill,
resulting in damage to the tool, your workpiece or serious personal injury.
If the drill runs smoothly under no load, but does not run smoothly under
load, then excessive pressure is being used.
4.
Check if the drill's moving parts are misaligned or binding before each use.
Correct the issue before using the drill to avoid an injury or damage to the
tool.
5.
Always be aware of the position of your hands relative to the drill. Avoid
awkward hand positions where a sudden slip could cause a hand to move
into the drill bit. Never reach behind or beneath the drill.
6.
Only use accessories that are specifically designed for use with the drill.
Ensure the drill bit is tightly installed.
7.
Only use a drill bit that exceeds the Speed rating (see Specifications).
8.
Before using the drill on a workpiece, test the drill by running it at the
highest speed rating for at least 30 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling. Check the tool
to determine the cause.
9.
Never touch the drill bit or workpiece during or immediately after use.
They may be hot and could inflict a burn injury.
10. Do not cover the air vents. Proper cooling of the motor is necessary to
ensure normal life of the tool.
11.
Never use a tool with a drill bit that is cracked or worn. Change the drill
bit before using it.
12. Do not place the drill down until the drill bit has stopped moving. The drill
may catch the surface of work material and wrench itself free, causing
injury to the user or others in the work area.
13. Avoid unintentional starts. Make sure the power switch is set to OFF
before connecting the drill to a power supply.
14. Make sure any adjustment mechanisms are secure before using the tool
15. Never point the drill towards yourself. It could inflict an injury.
16. Hold the drill by the insulated gripping surfaces when performing an
operation where the drill may contact hidden electrical wiring. The drill's
exposed metal surfaces may convey a shock to the operator from a 'live'
wire.
Page 7
LI-ION CORDLESS HAMMER DRILL
www.princessauto.com / 1-800-665-8685
9054685
Publicité
Table des Matières
